Pl G Thread with O Ring 90 Degree Elbow Fittings Pl G Bsp 1/8" 1/4" 3/8" 1/2" Pl Male Elbow Pneumatic Fitting with Seal Ring

• Customization: Available
• Customized: Customized
• Number of Cylinders: 8
• Model NO.: PL
• Type: Quick Connector
• Usage: Air transport Screwdriver, Impact Wrench, Air Drill, Grinding Machinery, Air Compressor, Air Line
• Brand: Snchk
• Work Temperature: 0--60
• Material: Plastic
• Transport Package: Bag Package
• Origin: China
• HS Code: 3917400000
• Production Capacity: 3000000/Month

Product Description

Type	PL L-type straight
Size	Tube 4-16mm Thread1/8,1/4,1/2.3/8
Fluid	Clean air
Used hose	PUhose or Nylon hose
Max Pressure	0-1.0mpa
Min Pressure	0-1.0mpa
Used temperature	0-60ºC
Used Pressure	0-1.0mpa

Features:
1. Designed for Polyurethane or Nylon tubing. 
2. Simple installation pneumatic push in connector.
3. After installation, the direction of the tube can be changed freely. 
4. Elliptical release ring help to connect tube easily by manual, no special tools required. 
5. Outside (and Inside where applicable) hexagonal wrench tightening. 
6.This Quick fittings are only used for industrial automatic apparatus and can not be applied on   any medicinal equipment.


Tips for choosing a quick coupler

01: How to choose a quick coupler:
1. The connecting thread and pipe part are not allowed to pull or rotate, otherwise the thread or pipe connection will fall off. In the case of pulling or turning, a rotary joint should be used.
2. The bending of the pipe should be greater than the minimum bending radius, otherwise the pipe is easy to break.
3. Inflammable, explosive or toxic gases such as coal gas, gas fuel and refrigerant cannot be transported in the pipe
4. General industrial water can be used.
5. The impulse pressure should be prepared, not exceeding the maximum operating pressure, otherwise it is easy to damage.

02: How to install the quick connector?
1. Before installation, confirm the correct model and size, and confirm that the product has no cracks or scars.
2. The length of the connecting pipe will change considering the pressure change, so the length should be left margin.
3. The joint box tube is not allowed to be twisted or stretched, and bear a negative torque, so as to avoid the joint damage, the tube damage, cracking or falling off.
4. When piping and fittings are screwed in, do not mix the chips of the piping thread and the small pieces of sealing material into the pipe. When using the sealing tape, leave the thread head about 2 pitches free and not wrap the sealing tape.

03: In which environments are quick connectors used?
1. Do not use quick connectors in electrostatic sensitive occasions, which will cause poor system actions and malfunctions.
2. Do not use the quick connector in the occasions where sparks occur. Sparks may cause fire hazards.
3. Do not use it in an environment where cutting oil, lubricating oil and coolant are in direct contact with liquids.